ISO INTERNATIONAL STANDARD 16525-2 First edition 2014-05-15 Adhesives Test methods for isotropic electrically conductive adhesives - Part 2: Determination of electrical characteristics for use in electronic assemblies Adhésifs-Méthodes d'essai pour adhésifs a conductivité électrique isotrope- Partie 2: Détermination des propriétés électriques pour utilisation dans des assemblages électroniques Reference number ISO 16525-2:2014(E) ISO Copyright International Organization for Standardization @ IS0 2014 I without license from IHS Not for Resale IS0 16525-2:2014(E) COPYRIGHT PROTECTED DOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved Not for Resale IS0 16525-2:2014(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Terms and definitions .... 4 Principle 5 Apparatus. 6 Procedure 6.1 Atmospheric conditions ..8 6.2 Measurement and calculation 6.3 Judgement .10 7 Test report. .11 ii ded by IHS under lic se with ISt ited without license from IHS Not for Resale