ISO INTERNATIONAL STANDARD 4118 Fourth edition 2016-07-01 Air cargo Non-certified lower deck containers - Design and testing Fret aérien - Conteneurs non-certifiés de pont inférieur - Conception et essais Reference number IS0 4118:2016(E) ISO @IS02016 No reproduction or networking permitted without license from IHS IS0 4118:2016(E) COPYRIGHT PROTECTED DOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either Iso at the address below or Iso's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org @ IS0 2016 - All rights reserved IS0 4118:2016(E) Contents Page Foreword ..V Introduction ..vi 1 Scope. ...1 2 Normative references 3 Terms and definitions ..2 4 Dimensions and ratings ..2 5 Design requirements. .4 5.1 General. 4 5.2 Base. .5 5.3 Body. .5 5.4 Doors .6 5.5 Internal tie-down .7 5.6 Placard holders. 7 5.7 Design options. 7 6 Flight conditions performance and testing .7 6.1 Pressure equalization and rapid decompression 7 6.2 Flight loads 7 7 Ground conditions performance and testing .9 7.1 General ..9 7.2 Bridging and cresting .9 7.3 Impacttest ..9 7.4 Rain test .9 7.5 Racking test .10 8 Markings ..10 9 Customs/security sealing (optional) ..11 10 Manufacturer's instructions ..11 11 Qualitycontrol ..12 11.1 Design and production. .12 11.2 Operations .12 Annex A (normative) Code DKc half-width contoured containers dimensions and design requirements .16 Annex B (normative) Code DKE/DKN half-width contoured containers dimensions and design requirements. .18 Annex C (normative) Code DKP half-width rectangular containers dimensions and design requirements. .20 Annex D (normative) Code DLF fuii-width contoured containers dimensions and design requirements ..22 Annex E (normative) Code DLP full-width rectangular containers dimensions and design requirements ..24 Annex F (normative) Code DPE/DPN half-width contoured containers dimensions and design requirements. .26 Annex G (normative) Code DQF full-width contoured containers dimensions and design requirements .28 Annex H (normative) Code DQP full-width rectangular containers dimensions and designrequirements .30 ytnematonalrights reerved iii thout license from IHS