ISO/TS TECHNICAL SPECIFICATION 11619 First edition 2014-02-15 Polyurethane tubing for use primarily in pneumatic installations Dimensions and specification Tubes en polyurethanne utilises principalement dans les installations pneumatiques-Dimensions et spécifications Reference number ISO/TS 11619:2014(E) ISO @IS02014 IS0/TS 11619:2014(E) COPYRIGHT PROTECTED DOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland i @ IS0 2014 - All rights reserved IS0/TS 11619:2014(E) Contents Page Foreword .iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Materials and construction ..1 5 Dimensions and tolerances ..1 5.1 Outside diameters, wall thickness and tolerances. 1 5.2 Length tolerances. .2 6 Performance requirements .2 6.1 Hydrostatic testing at 23 °C ± 2 °C 2 6.2 Hydrostatic testing at 60 °C ± 2 °C .3 6.3 Maximum working pressure. 3 6.4 Minimum bend radius .3 7 Type, routine and production testing ..4 8 Marking ..4 9 Recommendations for packing and storage ...4 Annex A (normative) Test frequency. .5 Annex B (informative) Recommended tests for production testing .6 Bibliography 7 @ IS0 2014 - All rights reserved ii