ISO/TS TECHNICAL SPECIFICATION 13399-204 First edition 2016-02-01 Cutting tool data representation and exchange - Part 204: Creation and exchange of 3D models Inserts for reaming Representation et échange des données relatives aux outils coupants Partie 204: Creéation et échange de modeles 3D - Plaquettes pour I'alésage Reference number IS0/TS13399-204:2016(E) ISO International Organization for Standardization @ IS0 2016 HEJIANG INST OF STANDARDIZATION C1 5956617 ed without license from IHS IS0/TS 13399-204:2016(E) COPYRIGHT PROTECTED DOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either Iso at the address below or Iso's member body in the country of the requester. IsO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinir DrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDIZAoIS 06 - All rights reserved Not for Resale, 2016/4/22 08:04:23 No reproduction or networking permited without license from IHS IS0/TS 13399-204:2016(E) Contents Page Foreword ..iv Introduction. ..vi 1 Scope. ..1 2 Normative references ..1 3 Starting elements, coordinate systems, planes ..1 3.1 General.. .1 3.2 Referencesystem. .2 3.3 Coordinate systems 2 3.3.1 General. .2 3.3.2 Coordinate system for the location of the insert 2 3.3.3 Coordinate system for the mounting of the insert. .3 3.4 Planes. .3 4 Design of the model. ..4 5 Reaming insert with one cutting edge and double plug chamfer .4 5.1 General ..4 5.2 Necessary properties .4 5.3 Basic geometry. ..5 5.4 Detailed geometry. .5 6 Reaming insert with two cutting edges and double plug chamfer .6 6.1 General .6 6.2 Necessary properties. .6 6.3 Basic geometry. .7 6.4 Detailed geometry. .1 7 Reaming insert with one cutting edge and rounded corner .8 7.1 General. 7.2 Necessary properties. .8 7.3 Basic geometry .9 7.4 Detailed geometry ..9 8 Reaming insert with two cutting edges and rounded corner .10 8.1 General 10 8.2 Necessary properties. 10 8.3 Basic geometry .10 8.4 Detailed geometry ..10 9 Reaming insert with special cutting profile ..11 9.1 General. .11 9.2 Necessary properties. ..11 9.3 Basic geometry ..12 9.4 Detailed geometry ..12 10 Attributes of surfaces - Visualization of the model features. ..12 11 Structure of the design elements (tree of model) .12 11.1 General 11.2 Example of the structure of the design elements .12 12 Data exchange model ..13 Annex A (informative) Information about nominal dimensions. ..14 Bibliography .15 iii icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ed without license from IHS