ISO/TS TECHNICAL SPECIFICATION 13399-401 Firstedition 2016-02-15 Cutting tool data representation and exchange - Part 401: Creation and exchange of 3D models Converting, extending and reducing adaptive items Représentation et échange des données relatives aux outils coupants - Partie 401: Création et échange de modeles 3D - Conversion, extension et réduction relatif aux attachements Reference number IS0/TS 13399-401:2016(E) ISO International Organization for Standardization @ IS0 2016 HEJIANG INST OF STANDARDIZATION C15956617 ed without license from IHS IS0/TS 13399-401:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Intenatinair PrganizationforStandardization nsee-ZHEJIANG INSTOFSTANDARDIZAoSQ6- All rights reserved Not for Resale, 2016/4/26 02:01:34 etworking permitted without license from IHS IS0/TS 13399-401:2016(E) Contents Page Foreword ..V Introduction. ..vii 1 Scope. 2 Normative references 3 Starting elements, coordinate systems, planes 2 3.1 General. .2 3.2 Reference system (PCS primary coordinate system) 3.3 Adaptive item position 3 3.3.1 General. .3 3.3.2 Prismatic adaptive position 3 3.3.3 Round adaptive position .3 3.4 Adjustment coordinate system at workpiece side .3 3.4.1 General 3 3.4.2 Designation of coordinate systems at workpiece side .3 3.4.3 Arrangement of coordinate system workpiece side .4 3.5 Mounting coordinate system. 3.6 Planes. ..6 4 Design of the model ..6 4.1 General 4.2 Necessary properties for the connection interface feature. .7 5 Converter, rotationally symmetric .7 5.1 General. 5.2 Necessary properties. ..8 5.3 Basic geometry. 5.4 Connection on workpiece side ..10 5.5 Rotational symmetric converter, complete ..11 6 Converter, stationary. ..12 6.1 General. ..12 6.2 Necessary properties. ..12 6.3 Basic geometry. .13 6.4 Connection on workpiece side .15 6.5 Stationary converter, complete .15 7 Extender .16 7.1 General .16 7.2 Necessary properties. .16 7.3 Basic geometry ..16 7.4 Connection on workpiece side ..17 7.5 Extender, complete .18 8 Reducer, primary design ..18 8.1 General. .18 8.2 Necessary properties. .19 8.3 Basic geometry. .19 8.4 Connection on workpiece side .20 8.5 Reducer, primary design, complete 21 9 Reducer, reverse design .21 9.1 General 21 9.2 Necessary properties. .22 9.3 Basic geometry. .22 9.4 Connection on workpiece side .23 9.5 Reducer, reverse design, complete .23 iii ISee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vithoutlicense from IHS Not for Resale, 2016/4/26 02:01:34