ISO/TS TECHNICAL SPECIFICATION 13399-70 First edition 2016-07-15 Cutting tool data representation and exchange - Part 70: Graphical data layout - Layer setting for tool layout Représentation et échange des données relatives aux outils coupants Partie 70: Disposition des données graphiques - Disposition en couches des parametres des outils Reference number IS0/TS13399-70:2016(E) ISO International Organization for Standardization ZHEJIANG INST OF STANDARDIZATION C1 5956617 @ IS0 2016 IS0/TS 13399-70:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internationai ibrg DrganizationforStandardization icensee-ZHEJIANG INSTOF STANDARDIZAoIS 06 - All rights reserved networking permited without license from IHS Not for Resale, 2016/9/22 06:57:25 IS0/TS 13399-70:2016(E) Contents Page Foreword ..iv Introduction. ..vi 1 Scope. 2 Terms and definitions 3 Layer concept ..4 4 Structure of the layers .5 4.1 General .5 4.2 Colouring of the layers .5 4.3 Grouping and definition of the layers. .6 4.3.1 Grouping. .6 4.3.2 Basic layer .6 4.3.3 Tool drawing (main view - function number 3.0.1) 4.3.4 NC-Geometry (CUT, NOCUT —function number 3.0.2) ..8 4.3.5 Extended tool drawing (further views - - function number 3.0.3) .9 4.3.6 Multilingual (global drawing - function number 3.0.4) .10 4.3.7 Tool reconditioning (supplier specific information - function number 3.0.5) ... 12 4.3.8 Machine equipment iayout (machining processes - function number 3.0.6). ....13 4.3.9 Drawing frame (multilingual and drawing space - function number3.0.7) ..15 4.4 Determination of the layer properties. 15 4.5 Rules of the layer concept. .26 5 Data concept. .27 5.1 Origin points and mating points 27 5.1.1 Rotationally symmetric cutting tool assembly 27 5.1.2 Non-rotationally symmetric cutting tool assembly 28 5.2 Rules for the Layer CUT and NOCUT .30 5.3 Rules for the concept of dimensioning .32 5.3.1 General .32 5.3.2 Cutting tool component 32 5.3.3 Cutting tool combination .33 Annex A (informative) Examples of the layer structure ..34 Bibliography .49 ii censee=ZHEJIANG INSTOF STANDARDIZATION C1 5956617 vided by IHS under I vithout license from IHS Not for Resale, 2016/9/22 06:57:25