TECHNICAL ISO/TS SPECIFICATION 13399-72 First edition 2016-07-15 Cutting tool data representation and exchange - Part 72: Creation of documents for the standardized data exchange Definition of properties for drawing header and their XML-data exchange Représentation et échange des données relatives aux outils coupants - Partie 72: Création de la documentation pour I'eéchange de données normaliseées -Définition des propriétés des cartouches de plans et leur échange de données en XML Reference number IS0/TS13399-72:2016(E) ISO International Organization for Standardization @ IS0 2016 STANDARDIZATION C15956617 I without license from IHS IS0/TS 13399-72:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Intenationaibr Prganization for Standardization icensee-ZHEJIANG INST OF STANDARDIZoISQ s.6 - All rights reserved Not for Resale, 2016/9/22 06:58:01 etworking permitted without license from IHS IS0/TS 13399-72:2016(E) Contents Page Foreword ..iv Introduction. ...vi 1 Scope. 2 Normative references 3 Terms and definitions .2 3.1 Main data. .2 3.2 Drawing data 3.3 Revisiondata 4 3.4 Item data 3.5 Customer data. 4 3.6 Processdata 5 3.7 Bill of material (BOM) data 5 4 Additional remark to the item in the bill of material 7 4.1 General .7 4.2 Data fields of the XML structure .7 4.3 Special data field 9 5 XML file .9 5.1 General. .9 5.2 XML tags. 9 5.3 Rootelement .10 5.4 Dataelement .10 5.5 XML schema determinations 10 5.5.1 XML tag <Admin-Data> .10 5.5.2 XML tag <Tool> 10 5.5.3 XML tag <Main-Data> ..10 5.5.4 XML tag <Drawing-Data> .11 5.5.5 XML tag <Revision-Data> .11 5.5.6 XML tag <Item-Data> .11 5.5.7 XML tag <Customer-Block> 12 5.5.8 XML tag <Customer-Data> .12 5.5.9 XML tag <Process-Data> ..12 5.5.10 XML tag <Sparepart-Data> .13 5.5.11 XML tag<BOM> ..13 5.6 Structure of the XML file. ..13 Annex A (informative) Example of an XML file of a turning tool .15 Annex B (informative) Structure of the XML schema. ..17 Bibliography ..21 iii ee=ZHEJIANG INSTOFSTANDARDIZATION C15956617 ed withoutlicense from IHS Not for Resale, 2016/9/22 06:58:01