ISO/TS TECHNICAL SPECIFICATION 15453 First edition 2017-04 Gas cylinders Seamless steel and aluminium-alloy gas cylinders Evaluation of existing gas cylinders and consideration of their safe use in other jurisdictions Bouteilles a gaz - Bouteilles a gaz en acier et en alliages d'aluminium, sans soudure - -Evaluation des bouteilles a gaz existantes et considérations relatives a leur utilisation en toute sécurité dans d'autres jurisdictions Reference number ISO/TS15453:2017(E) os1 International Organization for Standardization @ IS0 2017 vided by IHS underI Not for Resale, 2017/8/21 01:31:10 IS0/TS 15453:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org Internatinair PrganizationforStandardization nsee-ZHEJIANG INSTOFSTANDARDIZAoSQa7 - All rights reserved etworking permitted without license from IHS IS0/TS15453:2017(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Symbols and abbreviated terms .2 5 Requirements .3 5.1 Inspection body .3 5.2 Information to be provided .3 5.2.1 General .3 5.2.2 Basic information .3 5.2.3 Additional information. .3 5.3 Verification ofthe informationprovided .3 5.4 Cylinders subject to restriction on use. 4 5.5 Compatibilitywithintendedgasservice 4 5.6 Specific requirements for seamless steel cylinders used-in carbon monoxide service 5.7 Toxic gas service 4 5.8 Manufacturing certificate or equivalent 4 6 Acceptance by the inspector .4 6.1 General .4 6.1.1 Acceptance by documentary evidence 4 6.1.2 Alternative acceptance 6.1.3 Periodic inspection requirements .. 6 6.2 Final verification .6 7 Marks .6 8 Inspection report/certificate .6 Annex A (informative) Calculating minimum wall and base thicknesses using the mean diameter formula. .7 Annex B (informative) Correlation between tensile strength and hardness ..8 Bibliography 9 iii =ZHEJIANG INSTOF STANDARDIZATION C15956617