ISO INTERNATIONAL STANDARD 4086 Third edition 2001-10-15 Road vehicles 90 semi-trailer fifth wheel kingpin Interchangeability Vehicules routiers - Pivot d'attelage de 90 pour semi-remorque Interchangeabilite Reference number ISO 4086:2001(E) @ ISO 2001 ISO 4086:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or iso's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @IsO 2001-Allrights reserved ISO 4086:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 4086 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 15, Interchangeability of components of commercial vehicles and buses. This third edition cancels and replaces the second edition (IsO 4086:1982), which has been technically revised. servec ii