ISO INTERNATIONAL STANDARD 5264-2 Third edition 2011-02-15 Pulps Laboratory beating - Part 2: PFI mill method Pates - Raffinage de laboratoire - Partie 2: Méthode au moulin PFI Reference number ISO 5264-2:2011(E) @ISO 2011 py IHS under lic Not for Resale ISO5264-2:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by Iso member bodies. In COPYRIGHTPROTECTEDDOCUMENT @ ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2011 - All rights reserved I without license from IHS Not for Resale ISO 5264-2:2011(E) Contents Page Foreword IV Introductior 1 Scope 2 Normative references 3 Principle 4 Apparatus and auxiliary materials. 5 Sampling 6 Preparation of sample. 7 Procedure 8 Test report.. Annex A (normative) PFI mill.. Annex B (normative) Control and maintenance of the PFI mill. Annex C (informative) Checking the stability of the PFI mill.. Bibliography.... Copyright International Organization for Standardizalon ghts reserved ili IHS unde se from IHS Not for Resale