ISO INTERNATIONAL STANDARD 6310 Third edition 2009-07-01 Road vehicles Brake linings - Compressive strain test methods Véhicules routiers - Garnitures de freins - Methode d'essai de la compressibilite Reference number ISO 6310:2009(E) @ ISO 2009 yIHS under Not for Resale ISO 6310:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT @ ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ Iso 2009 - All rights reserved ed without license from IHS Not for Resale ISO 6310:2009(E) Contents Page Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols and units 5 Principles. 5.1 General 5.2 Test method A Couponsampleand/orairbrakepad 5.3 Test method B . Hydraulic disc brake pad assembly. 6 Test apparatus 7 Test stand specifications 7.1 Loading 7.2 Heated platen 7.3 Loading ram 8 Sampling 9 Test method. 9.1 9.2 Room temperature compressibility test.... 9.3 Temperature transfer and thermal expansion measurements. 9.4 Hot compressibility test.. 10 Test device deflection compensation 11 Verification of the test stand using reference samples.. 8 12 Test report Annex A (informative) Example test report 3 Copyrght International Organizaionforstandardizalonghts reserved ii from IHS Not for Resa