ISO INTERNATIONAL STANDARD 11393-5 Second edition 2018-09 Protective clothing for users of hand- held chainsaws - Part 5: Performance requirements and test methods for protective gaiters vetements de protection pourutilisateurs de scies d chaine tenues d la main - Partie 5: Exigences de performance et méthodes d'essai pour guetres deprotection Reference number IS0 11393-5:2018(E) ISO @ IS0 2018 IS011393-5:2018(E) COPYRIGHTPROTECTEDDOCUMENT IS02018 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or IsO's member body in the country of the requester: ISO copyright office CP 40i : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122.749 0111 Fax: +41 22 749 09 47 Email:copyright@iso.org Website: www.iso.org Published in Switzerland ii IS02018-Allrights reserved IS011393-5:2018(E) Contents Page Foreword iv Introduction. V 1 Scope. .1 2 Normative references .1 3 Terms and definitions .1 4 Requirements 2 4.1 General. 2 4.2 Fasteners 2 4.2.1 General. 2 4.2.2 Attachmentsystem 2 4.2.3 Twisting resistance of the gaiter 22 4.3 Innocuousness. 4.4 Specifiedprotective area 3 4.5 Ciassificationaccordingtochain speed 3 4.6 Cut resistance. 3 4.7 Ergonomics 3 5 Pre-treatment. .4 6 Test methods. 4 6.1 Test samples 4 6.2 Resistance to the chainsaw. 4 6.2.1 Principle 4 6.2.2 Test specimens. 4 6.2.3 Apparatus 4 6.3 Strengthof theattachment system 4 6.3.1 Principle. 4 6.3.2 Test samples 5 6.3.3 Apparatus 5 6.3.4 Preparing and fixing of samples for testing and procedure 5 6.4 Twisting resistance of the gaiter. 5 6.4.1 Principle 5 6.4.2 Test specimens. 5 6.4.3 Test equipment. 6 6.4.4 Procedure 6 6.5 Ergonomic testing 6 6.5.1 Ergonomic assessment 6 6.5.2 7 Procedures. 7 Test report. .7 8 Marking. .8 9 Pictogram .8 10 Information to be supplied by the manufacturer .9 Bibliography .11 @ IS0 2018 - All rights reserved iii