ISO INTERNATIONAL STANDARD 13596 First edition 2000-03-01 Aerospace Inserts, self-locking, with MJ threads, closed type, in metallic material, coated or uncoated Dimensions Aéronautique et espace - -Douilles filetées, a freinage interne et filetage MJ, du type ferme, en materiau metallique, revetues ou non revetues - Dimensions Reference number ISO 13596:2000(E) SO @ ISO 2000 copyrighted by UNE, C/ Genova, 6. 28004 Madrid, Spain (all rights reserved): Wed Feb 14 02:39:17 UTC 2024 Downloaded/printed for Georgia Institute of Technologv. This standard provided bv AENOR. No further ISO 13596:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is atrademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @IsO2000-Allrightsreserved @ copyrighted by UNE, C/ Genova, 6. 28004 Madrid, Spain (all rights reserved); Wed Feb 14 02:39:17 UTC 2024 ISO 13596:2000(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 13596 was prepared by Technical Committee ISO/TC 20, Aircraft and space vehicles Subcommittee SC 4, Aerospace fastener systems. ii