ISO INTERNATIONAL 14526-2 STANDARD First edition 1999-11-15 Plastics Phenolic powder moulding compounds (PF-PMCs) - Part 2: Preparation of test specimens and determination of properties Plastiques -Poudres a mouler phénoliques (PF-PMC) Partie 2: Preparation des éprouvettes et détermination des propriétés Referencenumber ISO14526-2:1999(E) ISO @ ISO 1999 ISO14526-2:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ISO 14526-2:1999(E) Foreword ISsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. SC 12, Thermosetting materials. After a transition period of, at the most, four years, the three parts of IsO 14526 (see below) will replace ISO 800:1992, of which they constitute a technical revision. so 14526 consists of the following parts, under the general title Plastics - Phenolic powder moulding compounds (PF-PMCs): Part 1:Designation systemand basis for specifications Part 2: Preparation of test specimens and determination of properties -Part 3: Requirements for selected moulding compounds