ISO INTERNATIONAL STANDARD 14529-1 First edition 1999-11-15 Plastics Melamine/phenolic powder moulding compounds (MP-PMCs) - Part 1: Designation system and basis for specifications Plastiques - Poudres a mouler a base de mélamine/phénol (MP-PMC) Partie 1: Systeme de deésignation et base de spécification Reference number ISO 14529-1:1999(E) ISO @ ISO 1999 ISO 14529-1:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ ISO 1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @Iso 1999-Allrights reserved ISO14529-1:1999(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies).The work of preparing International Standards is normally carried out through ISO technica liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 14529 may be the subject of International Standard ISO 14529-1 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 12, Thermosetting materials. ISO 4896:1990, of which they constitute a technical revision. IsO 14529 consists of the following parts, under the general title Plastics - Melamine/phenolic powder moulding compounds (MP-PMCs): Part1:Designation system and basis forspecifications Part 2: Preparation of test specimens and determination of properties Part3:Requirementsforselectedmoulding compounds @ ISO 1999 - All rights reserved ili