ISO INTERNATIONAL STANDARD 14530-2 First edition 1999-11-15 Plastics Unsaturated-polyester powder moulding compounds (UP-PMCs) - Part 2: Preparation of test specimens and determination of properties Plastiques - Poudres a mouler a base de polyester non saturé (UP-PMC)一 Partie 2: Préparation des éprouvettes et determination des propriétés Reference number ISO 14530-2:1999(E) A ISO @ ISO 1999 ISO14530-2:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ISO1999-All rightsreserved 1/997254500 ted without license from IHS Res-ale, 04/21/2007 02:22:27 MD ISO 14530-2:1999(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 14530 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 14530-2 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 12, Thermosetting materials. moulding compounds (UP-PMCs): Part1:Designation system and basisforspecifications Part 2: Preparation of test specimens and determination of properties -Part 3: Requirements for selected moulding compounds ii