ISO INTERNATIONAL STANDARD 15350 First edition 2000-12-15 Steel and iron Determination of total carbon and sulfur content Infrared absorption method after combustion in an induction furnace (routine method) Aciers et fontes Dosage du carbone et du soufre totaux - Méthode par absorption dans I'infrarouge apres combustion dans un four a induction (méthode pratique) Reference number ISO 15350:2000(E) ISO @ ISO 2000 ISO15350:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @ISO 2000 -All rights reserved ISO15350:2000(E) Contents Page Foreword. 1 Scope 2 Normative references 3 Principle. 4 Reagents. 5 Apparatus 6 Test method. 7 Sampling.. Procedure 8 6 Expression of results.. 10 Test report ... Annex A (informative) Examples of diagram for analytical principles Annex B (informative) Example calculation of a linearity check... Annex C (informative) Additional information on international cooperative tests. Annex D (informative) Graphical representation of precision data . @ ISO 2000 - All rights reserved ili