ISO INTERNATIONAL 2244 STANDARD Third edition 2000-03-01 Packaging Complete, filled transport packages and unit loads - Horizontal impact tests Emballages Emballages d'expédition complets et pleins et charges unitaires Essaisdechochorizontal Reference number ISO 2244:2000(E) ISO @ ISO 2000 ted without license from IHS Not for Res-ale ISO 2244:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ ISO 2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ IsO 2000 - All rights reserved tedwithout licensefrom IHS Not for Res-ale ISO2244:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies).The work of preparingInternational Standards is normally carried out through iSO technica liaison with IsO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of International Standard ISO 2244 was prepared by Technical Committee ISO/TC 122, Packaging, Subcommittee /SO/TC122) This third edition cancels and replaces the second edition (ISO 2244:1985) which has been technically revised. ili aganzanfrdadzaov Copyright Interr