ISO INTERNATIONAL 3230 STANDARD First edition 1998-03-15 Aerospace Rivets, solid, 10o° normal countersunk head with dome, metallic material, with or without surface treatment Dimensions Aeronautique et espace-Rivets ordinaires, a tete fraisée 10o°normale avecdome,enmateriaumetalligue,avecousanstraitementdesurface Dimensions n1i 1011 inn 11 IL/1 AADRIN KN ISO Reference number ISO 3230:1998(E) ISO3230:1998(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which atechnical committeehasbeenestablishedhasthe righttobe represented on that committee. International organizations, governmental and non- governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO/TC 20, Aircraft and space vehicles, Subcommittee SC 4, Aerospace fastenersystems. 101188 mn6 1011 @1SO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case postale 56 : CH-1211 Geneve 20 . Switzerland Internet central@iso.ch X.400 C=ch; a=400net; p=iso; 0=isocs; S=central Printed in Switzerland ii INTERNATIONALSTANDARD ISO3230:1998(E) @ISO Aerospace Rivets, solid, 1oo°normal countersunk with dome, metallic material, with or without surface treatment Dimensions 1 Scope This International Standard specifies the dimensions of solid rivets, 10o° normal countersunk head with dome, in metallic material, with or without surface treatment. It is intended for the drawing up of aerospace product standards. 2 Normative reference The following standard contains provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and ISO maintain registersofcurrentlyvalidInternationalStandards. ISO 286-2:1988, iSO system of limits and fits - Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts. 3 Configuration and dimensions See figure 1 and tables 1 to 3. Dimensions and tolerances are expressed in millimetres. They are applicable after any surface treatment. inn AANRINKN