ISO INTERNATIONAL STANDARD 5183-1 Second edition 1998-09-01 Resistance welding equipment Electrode adaptors, male taper 1:10 - Part 1: Conical fixing, taper 1:10 Equipement de soudage par résistance - Allonges d'electrode a embout amovible,conemale1:10 Partie 1: Emmanchement conique 1:10 ISO Reference number ISO 5183-1:1998(E) ISO 5183-1:1998(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 5183-1 was prepared by Technical Committee ISO/TC 44, Welding and allied processes, Subcommittee SC 6, Resistance welding. Iso 5183 consists of the following parts, under the general title Resistance welding equipment - Electrode adaptors, male taper 1:10: — Part 1: Conical fixing, taper 1:10 Part 2: Parallel shank fixing for end-thrust electrodes This second edition is a revision of the first edition (IsO 5183-1:1988), which has been technically revised Annexes A and B of this part of ISO 5183 are for information only @ISO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic nternational OrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 · Switzerland Internet iso@iso.ch Printed in Switzerland ii @ISO ISO 5183-1:1998(E) Introduction This part of ISO 5183 is an updated edition of ISO 5183-1:1988 and is largely based on the former version These electrode adaptors are designed to be used when electrodes are mounted at an angle. ii