ISO INTERNATIONAL STANDARD 7086-2 Second edition 2000-03-01 Glass hollowware in contact with food - Release of lead and cadmium - Part 2: Permissible limits Vaisselle creuse en verre en contact avec les aliments Emission deplombetdecadmium Partie 2: Limites admissibles Reference number ISO 7086-2:2000(E) ISO @ ISO 2000 ISO 7086-2:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ii @ISO 2000 -All rights reserved ISO 7086-2:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through ISO technical liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 7086-2 was prepared by Technical Committee ISO/TC 166, Ceramic ware, glassware and glass ceramicware in contactwith food Thissecondeditioncancelsandreplacesthefirstedition(lSO7986-2:1982),whichhasbeentechnicallyrevised ISO 7086 consists of the following parts, under the general title Glass hollowware in contact with food - Release of lead and cadmium: —Part 1: Test method —Part 2: Permissible limits @ ISO 2000 - All rights reserved ili