ISO INTERNATIONAL 8442-6 STANDARD First edition 2000-12-01 Materials and articles in contact with foodstuffs Cutlery and table holloware Part 6: Lightly silver-plated table holloware protected by lacquer Materiaux et objets en contact avec les denrées alimentaires - Coutellerie et orfevrerie de table Partie 6: Orfevrerie de table laquée et avec un léger placage d'argent Referencenumber ISO 8442-6:2000(E) ISO @ ISO 2000 ISO8442-6:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland ISO 8442-6:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical liaison with IsO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3. rights. IsO shall not be held responsible for identifying any or all such patent rights. accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this standard, read "...this European Standard.." to mean "...this International Standard...". isO 8442 consists of the following parts, under the general title Materials and articles in contact with foodstuffs - Cutlery and table holloware: Part 1: Requirements for cutlery for the preparation of food :Part 2: Requirements for stainless steel and silver-plated cutlery Part 3: Requirements for silver-plated table and decorative holloware Part 4: Requirements forgold plated cutlery Part 5: Specification for sharpness and edge retention test of cutlery :Part 6: Lightly silver-plated table holloware protected by lacquer Part 7: Requirements for table cutlery made of silver, other precious metals and their alloys Part 8: Requirements for silver table and decorative holloware Annexes A to I form a normative part of this part of ISO 8442. Annex J is for information only